Refrigerator Repair in Kearns, UT
Refrigerators in Kearns kitchens range from twenty-year-old top freezers that keep going to new French door models packed with electronics. Latin Appliances LLC diagnoses both, and when a repair is not worth the value of the unit we say so plainly instead of selling you parts.
Local refrigerator repair in Kearns, UT
Kearns is full of well-kept mid-century homes with laundry in the basement or garage and kitchens that have been updated one appliance at a time. Appliance repair in Kearns tends to mean working on a mix of older, very repairable machines and newer electronic models, and we are set up for both — for homeowners and for landlords who need a straight answer fast.
Kearns sits minutes from Magna, West Valley City, Taylorsville, West Jordan, and Murray, which keeps our drive times short and our scheduling flexible.
Sealed system service is not offered on every unit. Whether it makes sense depends on the model, the age of the refrigerator, parts availability, and whether the repair is worth the value of the appliance — we give you a straight answer after diagnosis.
Common refrigerator problems we repair in Kearns
Refrigerator not cooling
No cooling at all can be a failed evaporator fan, a defrost system stuck in a frost-over, a bad control board, or a compressor that is no longer starting.
Freezer works but the fridge is warm
This classic split points to an evaporator fan that stopped, a damper stuck closed, or an ice-blocked evaporator coil starving the fresh food section of cold air.
Ice maker not making ice
We check the water inlet valve, fill tube for ice plugs, ice maker module, and the freezer temperature — an ice maker will not cycle if the compartment is not cold enough.
Water leaking
Water on the floor is usually a clogged defrost drain, a cracked water line, or a failed inlet valve. Inside the freezer, an ice sheet under the drawer points straight at the drain.
Noisy refrigerator
Ticking, buzzing, or a loud hum can be the condenser fan, evaporator fan blade hitting ice, or a compressor on its way out. Locating the noise correctly avoids replacing the wrong part.
Frost buildup
Heavy frost on the back wall means the defrost system — heater, thermostat, bimetal, or board — is not completing its cycle.
How we diagnose and repair refrigerators
Temperature and airflow mapping
We take real temperatures in both compartments and trace airflow before touching a component.
Defrost system testing
Defrost heater, bimetal thermostat, and the board's defrost cycle are tested live so we know whether ice is the cause or a symptom.
Fan and control board checks
Evaporator and condenser fan motors are checked for voltage and draw, and board outputs are verified rather than assumed.
Compressor diagnosis
Start relay, overload, and compressor windings are tested to tell a cheap relay fix apart from a failing compressor.
Sealed system diagnosis
When symptoms point to a restriction or refrigerant loss, we diagnose the sealed system and explain what it means for your specific unit.
Brands we service in Kearns
Why Kearns homeowners choose Latin Appliances
- Family-owned, local appliance repair — bilingual English/Spanish service
- Licensed and insured in the state of Utah
- Fast scheduling; same-day service may be available
- Clear estimate before you approve the repair
- Honest repair vs. replacement recommendations when the numbers say so
- Technicians who work in Kearns every week, not a call center
Straightforward pricing
Latin Appliances LLC uses a flat labor rate plus parts for most appliance repairs. After diagnosis, we provide the repair recommendation, parts needed, and total estimate before moving forward.
Some unusual repairs, specialty appliances, built-in appliances, sealed system work, commercial-style units, or additional work may be quoted differently depending on the situation.
Book NowRefrigerator Repair in Kearns — FAQs
Request service for refrigerator repair in Kearns, UT
Book online in under a minute or call us directly. We will confirm your window, diagnose on site, and give you the full estimate before any repair starts.